Recovery support tasks

This section describes standard recovery tasks that are required in performing the recovery procedures described in this chapter. Use recovery tasks only for the procedure to which they apply. These tasks support recovery by letting you manipulate and identify critical data in the replication system.

Refer to this section for background in performing the recovery procedures in this chapter.

Table 7-5 lists the recovery support tasks.

**Table 7-5: Overview of recovery support tasks**
Recovery support task	See
Rebuild stable queues	“Rebuilding stable queues”
Check for Replication Server loss detection messages after rebuilding stable queues	“Loss detection after rebuilding stable queues”
Put Replication Server in log recovery mode	“Setting log recovery for databases”
Check for Replication Server loss detection messages after setting log recovery for databases	“Loss detection after setting log recovery”
Determine which dumps and logs to load	“Determining which dumps to load”
Adjust database generation numbers	“Adjusting database generation numbers”