Chapter 3: Creating Embedded EAServer Installations
Listener ports
EAServer includes several preconfigured network listeners
for the supported protocols. For new installs, configure the listener
ports by setting the parameters listed in Table 3-3. These settings
are ignored if you are upgrading an existing installation. You can
also configure these settings after the install completes using
Jaguar Manager or jagtool as described in the EAServer
System Administration Guide.
The installer checks to see if the specified ports are already
in use. You can configure the installer to either ignore port conflicts
or to scan for free ports. For example, these settings configure
the install to not scan for free ports and to ignore conflicts:
-W PortScan.silentResolvePortConflict=False
-W PortScan.silentIgnorePortConflict=True
To scan for free ports and write the port numbers to the log
file eas_install.props, use these
settings:
-W InstallLogFilename.value="$W(SilentInstallLocation.value)\EAServer\eas_install.props"
-W PortScan.silentResolvePortConflict=True
-W PortScan.silentIgnorePortConflict=False
These settings create the log file as eas_install.props in
the install location. You can modify the file name and location
by editing the value of the -W InstallLogFilename.value parameter.
Table 3-3: Silent installer listener port
parameters
Parameter
|
Specifies
|
|---|
-W InstallLogFilename.value
|
The name and path of a log file where
the listener port numbers are recorded. If you specify automatic
detection of free ports, you can read the port numbers from this
file after the install.
|
-W PortScan.silentResolvePortConflict
|
Whether to scan for unused ports if a
specified port is in use. The installer tries new port numbers by
incrementing by 100 between each tested port number, for example,
9000, 9100, 9200, and so forth.
|
-W PortScan.silentIgnorePortConflict
|
Whether to allow the install to continue
if a specified port is in use. If you set this parameter to False,
the installer fails with an error if a port is in use. If you have
enabled port scanning by setting -W PortScan.silentResolvePortConflict to
True, the installer scans for free ports before evaluating port
conflicts.
|
-W PortScan.iiop
|
The initial port for the Jaguar_iiop
listener.
|
-W PortScan.iiops1
|
The initial port for the Jaguar_iiops1
listener.
|
-W PortScan.iiops2
|
The initial port for the Jaguar_iiops2
listener.
|
-W PortScan.http
|
The initial port for the Jaguar_http
listener.
|
-W PortScan.https1
|
The initial port for the Jaguar_https1
listener.
|
-W PortScan.https2
|
The initial port for the Jaguar_https2
listener.
|
-W PortScan.tds
|
The initial port for the Jaguar_tds
listener.
|
-W PortScan.OpenServer
|
The initial port for the Jaguar_OpenServer
listener.
|
|
Copyright © 2004. Sybase Inc. All rights reserved.
|
|
View this book as PDF 