You can configure EAServer to use the JDK versions described in “JDK versions”. For each JDK version, you can install the JDK, use an existing installation, or not use that JDK version at all.
The parameters in Table 3-4 allow you to configure the EAServer installation to use JDK installations that are already in place, rather than installing JDKs with the EAServer installation.
Parameter |
Specifies |
---|---|
-V EASJDKUseExisting_JDK14_CheckBox |
Whether to use an existing JDK 1.4 installation. To use an existing installation, set this parameter to true and specify the location as the value of the next parameter. Also, set the value of JDK14.active to false in the feature selection section. |
-V EAS_JDK14_Install_Location |
If you are using an existing JDK 1.4 installation, the location where it is installed. Verify the version and patch level of the specified JDK as described in “JDK versions”. |
-V EASJDKUseExisting_JDK15_CheckBox |
Whether to use an existing JDK 1.5 installation. To use an existing installation, set this parameter to true and specify the location as the value of the next parameter. Also, set the value of JDK15.active to false in the feature selection section. |
-V EAS_JDK15_Install_Location |
If you are using an existing JDK 1.5 installation, the location where it is installed. Verify the version and patch level of the specified JDK as described in “JDK versions”. |
-V EASJDKUseExisting_JDK16_CheckBox |
Whether to use an existing JDK 1.6 installation. To use an existing installation, set this parameter to true and specify the location as the value of the next parameter. Also, set the value of JDK16.active to false in the feature selection section. |
-V EAS_JDK16_Install_Location |
If you are using an existing JDK 1.6 installation, the location where it is installed. Verify the version and patch level of the specified JDK as described in “JDK versions”. |
To install a JDK from your install image, enable the feature parameter for that JDK and include the required files in your image, as listed in Table 3-5.
Parameter |
Specifies |
Comments |
---|---|---|
-P JDKs.active |
Whether to install any JDKs from the install image |
Must be set to true or the next two parameters are ignored |
-P JDK14.active |
Whether to install JDK 1.4 |
|
-P JDK15.active |
Whether to install JDK 1.5 |
|
-P JDK16.active |
Whether to install JDK 1.6 |