If the wash area is too small for the usage in a buffer pool, operations that need a clean buffer may have to wait for I/O to complete on the dirty buffer at the LRU end of the pool or at the victim marker. This is called a dirty buffer grab, and it can seriously impact performance. Figure 19-5 shows a dirty buffer grab on a strict replacement policy cache.
Figure 19-5: Small wash area results in a dirty buffer grab
You can use sp_sysmon to determine whether dirty buffer grabs are taking place in your memory pools. Run sp_sysmon while the cache is experiencing a heavy period of I/O and heavy update activity, since it is the combination of many dirty pages and high cache replacement rates that usually causes dirty buffer grabs.
If the “Buffers Grabbed Dirty” output in the cache summary section shows a nonzero value in the “Count” column, check the “Grabbed Dirty” row for each pool to determine where the problem lies. Increase the size of the wash area for the affected pool. This command sets the wash area of the 8K memory pool to 720K:
sp_poolconfig pubs_cache, "8K", "wash=720K"
If the pool is very small, you may also want to increase its pool size, especially if sp_sysmon output shows that the pool is experiencing high turnover rates.
See the Performance and Tuning Guide for more information.
