Restarting Replication Server

Restart Replication Server.

1. Modify the old runserver file, run_ servername .bat, where servername is your Replication Server name, to replace the old binary with the new binary in %SYBASE%\REP-15_5\bin\repserver, then start Replication Server from %SYBASE%\REP-15_5\bin\repserver.
   
2. If you are using Adaptive Server as the RSSD, restart the RepAgent for the RSSD:

   sp_start_rep_agent RSSD_name

3. Resume log transfer to Replication Server from all Replication Agents for primary databases, and RSSD or eRSSD:

   resume log transfer from all

4. If there are incoming routes to dest_rs, the Replication Server you upgraded and now restarted, log in to the source Replication Server and resume all routes to dest_rs to allow the source Replication Server to begin sending queued messages to dest_rs. At the source Replication Server, execute:

   resume route to dest_rs