Fix problems encountered when using the alter
route command.
- Quiesce
the replicated data system before executing alter
route.
See Replication
Server Administration Guide Volume 1.
- If you are changing a direct route to an indirect
route, or if you are changing the intermediate site in an indirect
route, create a route from the new intermediate site to
the destination site.
- Execute rs_helproute at
the destination Replication Server to determine the success of an alter
route command.
Make sure that the output reflects the route
change. If the route change did not succeed, follow the troubleshooting
procedures in Replication Server Troubleshooting Guide > Route Problems > Problems with Creating Routes > Output from rs_helproute at the Source Replication Server.