You can upgrade manually without using a wizard or utility.
To upgrade SAP ASE manually, use the upgrade
executable located in %SYBASE%\ASE-16_0\bin.
- Shut down:
- The pre-16.0 SAP ASE server
- All additional servers that are using the same
%SYBASE% directory as the SAP ASE
- If you installed ASE 16.0 into a directory other than the old ASE directory,
copy the server entry from the old interfaces
file to the new interfaces file.
- Copy the server_name.cfg file from old directory to the new
%SYBASE% directory.
- Start the 16.0 server with the old master
device from the old server.
- Restart all the additional servers you shut down after
shutting down the pre-16.0 SAP ASE.
- Run upgrade. If problems occur, fix
them, and re-run the upgrade process.
- Reinstall the SAP ASE-supplied stored procedures to prevent any errors caused
from changes to the system catalogs.