To be ready to switch to the standby database, you must enable replication for the tables and stored procedures in the standby database that you want to replicate into the new standby database after the switch.
If you initialized the standby database using the dump and load or mount commands, the tables and stored procedures in the standby database will have the same replication settings as the active database.
If you initialized the standby database using bcp, enable replication for these objects by using sp_setreptable or sp_reptostandby, and sp_setrepproc. To enable replication for objects in the standby database, adapt the procedure for enabling replication for objects in the active database.