dest_rsid
|
int
|
ID of a data server or
Replication Server
|
through_rsid
|
int
|
Destination is reached
through this Replication Server. For a direct route, the value of through_rsid is
the same as that of dest_id.
|
source_rsid
|
int
|
Replication Server where
this route is defined
|
status
|
tinyint
|
Status of the route:
1 – being initialized
2 – route is valid at this site (route
is valid when status is 2 at both the source and destination Replication
Servers)
3 – dropping this route gracefully
4 – dropping this route immediately
|
suspended
|
tinyint
|
One of these values:
0 – route is active
1 – route is suspended
2 – route is being rebuilt. In the process
of setting the truncation point.
3 – route is suspended. In the process
of setting the truncation point.
8 (mask) – for an RSI outbound queue, instructs
the replicate Replication Server to set the locater field
in the rs_locater table to 0, for
this sending Replication Server.
|
src_version
|
int
|
Version of source Replication
Server for this route. Note that this version is the RSI version
(not what appears in the rs_config stored
procedure under current_rssd_version).
Refer to the Release Bulletin for Replication Server for
any additional supported version numbers.
|