Setting Relay Server General Properties

Set basic connection properties for the Relay Server.

Prerequisites
Launch the Relay Server configuration wizard.
Task
  1. Specify these property values:
    • Host – either the host name of the Relay Server, or the host name of the load balancer (if any).
    • Http port – the Relay Server HTTP port.
    • Https port –
      Note: If Relay Server uses HTTPS and certificates, clients other than replication may not be able to connect: messaging applications only support HTTP, and hybrid workflow container applications for iOS support HTTPS — but not certificates.
      the Relay Server HTTPS port.
    • URL suffix – the URL suffix used by the Outbound Enabler to connect to a Relay Server.
    • (Optional) Description – a user-definable description of the Relay Server.
  2. Add or remove HTTP credentials as required:
    1. Check Configure relay server HTTP credentials.
    2. To add new credentials, specify these property values and click +:
      • User name – user name for RSOE authentication on the Web server (Relay Server host).
      • Password – password for RSOE authentication on the Web server.
    3. To remove credentials from the list, select the corresponding user name, then click X.
  3. Click Next.
Parent topic: Viewing or Editing Relay Server Properties
Previous topic: Relaunching the Relay Server Configuration Wizard
Next topic: Define Server Farms and Cluster Nodes