Before proceeding, verify that key services are functioning, you can
log in to Sybase Control Center, and from
Sybase Control Center you can see the properties of the node you just
installed.
In the location of the installation log
file referenced below, SUP_HOME is the installation location you
specified (default is C:\Sybase\UnwiredPlatform)..
- Check the installation log at SUP_HOME\InstallLogs\UPInstall.log.
A search for "error" should not find anything.
- Verify
that these services are started automatically, otherwise, you must start them
manually. Open the Services panel from Windows Control Panel and check the start-up
state
for:
- Sybase Control Center
X.X
- Sybase Unwired SampleDB
- Sybase Unwired Server
- Log in to Sybase Control Center. If you are installing a
scale-out node, go to one of the systems where you installed
Unwired Server as an application server node.
From Windows, select .
- Verify
that the node you just installed is accessible from
Sybase Control Center and that you can see the properties
of that node.