Using a Response File

Use the silent installation response file to install Sybase Event Stream Processor on multiple computers.

Run a response file as often as necessary to install the Sybase Event Stream Processor on the required number of machines.

On the target machine, for each installation, enter the following command at the command line:

setupConsole.exe -i silent -f <response file> -DRUN_SILENT=true -DAGREE_TO_SYBASE_LICENSE=true

where <response file> is the input response file.

The specified file name must be an absolute path.

If you do not specify a response file, the installer.properties file located in the same directory as the installation file is used. If an installer.properties file does not reside within this directory, the installer does not launch properly.

Tip: If Studio does not start, try manually deleting the .metadata folder within the workspace directory.