Control Flow

The adapter loads its configuration from a file (for example, adapter.xml) and validates it against the adapter schema (wombatadapter.xsd), which includes the API-wide controller schema (controller.xsd).

You cannot edit schemas.

The Adapter Controller creates an instance of the adapters, and receives and executes start, stop, and status commands.

• Start Command
  The start command configures and starts the adapter command and control interface.
• Stop Command
  The stop command disconnects the SpPublisher and SpSubscriber from Event Stream Processor, causes the Data Source Handler to close the session and disconnect from the datasource, stops the Adapter Controller from listening to user commands, and terminates the adapter process.
• Status Command
  The status command reports the adapter status, and the Adapter Controller prints out its status: either running or stopped.