Add a watch element to a breakpoint.
Prerequisites
- Access the Debugger view of the Run-Test perspective
- Enable Trace mode
Task- Click Trace On.
- Right-click in the Watch table.
- Select Add Watch.
- Select a stream from the Watch Choices box.
- Select the type of watch you want to set up on that stream.
- Click Add.
The watch appears in the table at the bottom of the dialog box.
- Click OK.
The watch appears in the Watch table in the Debugger view.
- To remove watches, right-click within the Watch table and select, either:
- Remove Watch to remove a single select watch variable, or,
- Remove All Watches to remove all watch variables.