Setting Up Unwired Server Nodes

After you confirm that the generic service is available for the data tier cluster, install and configure the Unwired Server components.

1. Run the Sybase Unwired Platform installer.
   Use the installer to set up your enterprise deployment license, installation folder, and so on. See Sybase Unwired Platform Installation Guide.
2. Choose the node to install.
   The first node of the Unwired Server cluster determines the cluster name by adopting the host name. For subsequent nodes, you need not provide a node name. Each Unwired Server that joins the cluster assumes the cluster name, with an incremented number. For example, the first server is named SybaseUnwiredPlatformMYHOSTServer1, the second SybaseUnwiredPlatformMYHOSTServer2, and so on.

   Note: If the cluster is to be associated with a hosted Relay Server, use only alphanumeric names. Relay Server does not allow any non-alphanumeric character in a server name.
3. When prompted to choose the installation type, choose Cluster Setup and click Next.
4. When prompted to choose setup type, select either Install the first server node and connect it to the data tier or Install an additional server node and connect it to the data tier. Provide the Microsoft cluster name (that is, the MS Cluster Access point as the host name of the data tier).
   Continue running the installer as documented in Sybase Unwired Platform Installation Guide, Installing the Unwired Server.