Replication Server Route Properties

Replication Server route property sheets contain all the standard process connection tabs, along with the Route Options tab and the Security tab.

Route Options Tab

The following properties are available on the Route Options tab:

Property

Description

User name

Specifies a name for the user.

Scripting name: UserName

Password

Specifies a password for the user.

Scripting name: Password

Next site

Specifies that the connection passes through an intermediate Replication Server site.

Scripting name: NextSite

Disk affinity

Specifies an allocation hint for assigning the next partition. Enter the logical name of the partition to which the next segment should be allocated when the current partition is full.

Scripting name: RouteParameter_disk_affinity

RSI batch size

Specifies a number of bytes sent to another Replication Server before a truncation point is requested. The range is 1024 to 262144.

Scripting name: RouteParameter_rsi_batch_size

Save interval

Specifies the number of minutes that the Replication Server takes to save messages after they have been successfully passed to the destination Replication Server.

Scripting name: RouteParameter_save_interval

Large message

Specifies route behavior if a large message is encountered. This parameter is applicable only to direct routes where the site version at the replicate site is 12.1 or earlier. Values are "skip" and "shutdown."

Scripting name: RouteParameter_rsi_xact_with_large_msg

RSI synchronize interval

Specifies the number of seconds between RSI synchronization inquiry messages. The Replication Server uses these messages to synchronize the RSI outbound queue with destination Replication Servers. Values must be greater than 0.

Scripting name: RouteParameter_rsi_sync_interval

RSI packet size

Specifies the packet size, in bytes, for communications with other Replication Servers. The range is 1024 to 8192.

Scripting name: RouteParameter_rsi_packet_size

RSI fadeout time

Specifies the number of seconds of idle time before Replication Server closes a connection with a destination Replication Server. The value -1 specifies that Replication Server will not close the connection.

Scripting name: RouteParameter_rsi_fadeout_time

Primary connection

[v15.7 and higher] Specifies the data connection which carries the data that will transit on the route. If this property is set to None, then the route will accept data arriving from any data connection.

Scripting name: PrimaryConnection

Security Tab

The following properties are available on the Security tab:

Property

Description

Message confidentiality

Specifies whether Replication Server sends and receives encrypted data. If set to "required," outgoing data is encrypted. If set to "not required," Replication Server accepts incoming data that is encrypted or not encrypted.

Scripting name: SecurityParameter_msg_confidentiality

Unified login

Specifies how Replication Server seeks to log in to remote data servers and accepts incoming logins.

Scripting name: SecurityParameter_unified_login

Use security services

Specifies whether to use security services. If use_security_services is "off," no security features take effect. This parameter can only be set by configuring replication server.

Scripting name: SecurityParameter_use_security_services

Message integrity

Specifies whether data is checked for tampering.

Scripting name: SecurityParameter_msg_integrity

Message origin check

Specifies whether the source of data should be verified.

Scripting name: SecurityParameter_msg_origin_check

Message replay detection

Specifies whether data should be checked to make sure it has not been read or intercepted.

Scripting name: SecurityParameter_msg_replay_detection

Message sequence check

Specifies whether data should be checked for interception.

Scripting name: SecurityParameter_msg_sequence_check

Mutual authorization

Specifies a remote server to provide proof of identify before a connection is established.

Scripting name: SecurityParameter_mutual_auth

Security mechanism

Specifies the name of the third-party security mechanism enabled for the pathway.

Scripting name: SecurityParameter_security_mechanism