This section explains how to define new LU 6.2 connection configurations to TRS and how to remove existing connection configurations.
Every connection between TRS and a transaction processing region must be defined to TRS. When you execute an RPC, TRS chooses a connection with a region value that matches the definition in the RPC to execute the transaction.
Consider the following:
If you are not using parallel sessions, do not use the same LU 6.2 pair or more than one session on it for more than one TRS, or for any other LU 6.2 application. Dedicate a separate set of connections for each TRS.
If you use parallel sessions, you can use an LU 6.2 pair for TRS. However, be sure that you configure a sufficient number of sessions for the total number of Open ServerConnect users and Open ClientConnect users. Also, be sure that the workstation is configured as the “contention winner.” (Check with your mainframe system programmer.)
When possible, Sybase recommends limiting use of an
LU 6.2 pair to only one TRS other LU 6.2 application. This configuration
simplifies the analysis if there are any LU 6.2 problems.
| Copyright © 2005. Sybase Inc. All rights reserved. |
|
|
