Make a copy of this
worksheet for each database you add to the replication system. Fill
out the worksheet as you read Chapter 1, “Preparing to Install and Configure Replication Server.” Refer to the information on the
worksheet when you use rs_init to add
the database to your replication system.
Required worksheet items are marked with an asterisk (*). rs_init has
default values for items that are not marked.
To use the default values, leave the unmarked items blank and fill
them in on the worksheet when you run rs_init.
Replication
Server information
|
|
Replication Server name:*
|
RS SA user:*
|
RS SA password:*
|
Replication
Server interfaces information
|
|
Host name/address:*
|
Port:*
|
Name alias:
|
Database
information
|
|
Adaptive Server name:*
|
SA user:
|
SA password:
|
Database name:
|
Will the database be replicated?*
|
Yes
|
No
|
Maintenance user:
|
Maintenance password:
|
Is this a physical connection for an
existing logical connection?
|
Yes
|
No
|
Logical
connection information
Complete if you selected Yes for “Is this
a physical connection for an existing logical connection?”
|
|
Is this an active connection or a standby
connection?*
|
Active
|
Standby
|
Logical DS name:*
|
|
|
Logical DB name:*
|
|
|
Complete
the rest of the items in this section only if you selected “Standby” in
response to “Is this an active connection or standby connection?”
|
|
Active DS name:*
|
Active DB name:*
|
Active DB SA user:*
|
Active DB SA password:*
|
Initialize standby using dump and load?*
|
Yes
|
No
|
Use dump marker to start replicating
to standby?*
|
Yes
|
No
|
Complete
the following three sections if you selected Yes for “Will
the database be replicated?”
|
Database
RepAgent information
|
|
RS user:
|
RS password:
|
