Enter operator commands from the MVS console using the MODIFY command.
The following is the syntax of the MODIFY command (include the commas in this command as shown in the example):
F jobname,target,command
where:
F is the MODIFY command keyword.
jobname is the LTM for MVS started task name or batch job name, depending on whether LTM for MVS was initiated as a started task or batch job.
target is either of the following options:
C specifies that the command is passed to LTM for MVS.
E specifies that the command is passed to Replication Extract.
command is the MVS operator command you want to execute.