Summary information |
|
|---|---|
Default value |
1 (on) |
Valid values |
0 (off), 1 (on) |
Status |
Static |
Display level |
Comprehensive |
Required role |
System Administrator |
The tcp no delay parameter controls TCP (Transmission Control Protocol) packet batching. The default value is 1, which means that TCP packets are not batched.
TCP normally batches small logical packets into single larger physical packets (by briefly delaying packets) fill physical network frames with as much data as possible. This is intended to improve network throughput in terminal emulation environments where there are mostly keystrokes being sent across the network.
However, applications that use small TDS (Tabular Data Stream™) packets may benefit from disabling TCP packet batching. To disable TCP packet batching, set tcp no delay to 1.
Disabling TCP packet batching means that packets will
be sent, regardless of size; this will increase the volume of network
traffic.
