Updating the Authentication Type to LDAP Authentication

If the cluster authentication type in Event Stream Processor has changed to LDAP, update the authentication type in the ProductModule.xml file to LDAP.

1. Open the ProductModule.xml file in the <SCC_DIR>\plugins\ESPMAP directory.
2. Uncomment out the <scc:ap_definition> block under LDAP authentication to enable LDAP authentication. For example:

   <!--   The following scc:ap_definition shall be uncommented out if LDAP authentication is enabled   --> 
   - <!--   Profile for LDAP authentication    --> 
               <scc:ap_definition name="ESP_Node_LDAP_Authentication" description="Authenticate with ESP Node by LDAP">
                   <scc:ap_value_defn key="ldap_username" required="no" default="sccadmin">
                       <scc:prompt reskey="RESKEY_AP_PROMPT_USERNAME" default="Username"/>
                       <scc:tooltip reskey="RESKEY_AP_TT_USERNAME" default="Enter the username"/>
                   </scc:ap_value_defn>
                   <scc:ap_value_defn key="ldap_password" required="no" obscure="true" default="">
                       <scc:prompt reskey="RESKEY_AP_PROMPT_PASSWORD" default="Password"/>
                       <scc:tooltip reskey="RESKEY_AP_TT_PASSWORD" default="Enter your password"/>
                   </scc:ap_value_defn>
               </scc:ap_definition>
   

   Note: Only one scc:ap_definitions block can take effect at a time so comment out blocks for all other authentication types.