Installing Replication Agent in console mode uses the same steps as those for the GUI wizard, except you:
Note: If there is not enough disk space in your default temporary directory, set the IATEMPDIR (Linux or UNIX) or TMP (Windows) environment variable to a directory that has enough space. Include the full path to this directory.
-
Invoke the installation program wizard at the
command prompt, and
-
Use only the keyboard to select all of the installation
options.
This installation procedure uses the installation program
wizard in console mode, which requires either:
-
A monitor
and keyboard on the Replication Agent host machine, or
-
A monitor and keyboard on a remote machine configured
to control the Replication Agent host machine.
See Installation Program Command Line Options for information about the command line options you can use with the installation program.
Note:
This installation procedure does not require
a pointing device or a GUI environment to install the Replication Agent software.
If errors occur during the installation, the installation
program displays error messages. Exit the installation program wizard
to correct the cause of the error, and then restart the installation
program.
If the software is installed successfully, you see a message
confirming the successful installation.