Troubleshooting Problems with Altering Routes

Fix problems encountered when using the alter route command.

1. Quiesce the replicated data system before executing alter route.
   See Replication Server Administration Guide Volume 1.
2. If you are changing a direct route to an indirect route, or if you are changing the intermediate site in an indirect route, create a route from the new intermediate site to the destination site.
3. Execute rs_helproute at the destination Replication Server to determine the success of an alter route command.
   Make sure that the output reflects the route change. If the route change did not succeed, follow the troubleshooting procedures in Replication Server Troubleshooting Guide > Route Problems > Problems with Creating Routes > Output from rs_helproute at the Source Replication Server.