Upgrade to Adaptive Server 15.7 SP100

If you are performing a major upgrade from an Adaptive Server version earlier than 15.x, you are ready to upgrade Adaptive Server after you successfully run the preupgrade utility.

Note: sysconfig.exe cannot connect to an Adaptive Server that uses a named pipe directory service. You must remove the named pipe directory service from the interfaces file before upgrading the Adaptive Server.

Upgrading Adaptive Server on Windows
Use the Server Config utility to upgrade Adaptive Server.
Testing the Adaptive Server Upgrade
Test the server.
Manually Upgrading to Adaptive Server
You can upgrade manually without using a wizard or utility.
Installation of Version 15.7 SP100 over an Existing 15.x Adaptive Server
Use a binary overlay to install Adaptive Server 15.7 SP100 over an existing version 15.x installation directory.
Upgrading in Silent Mode
To perform a silent, or unattended installation, run the installer and provide a response file that contains your preferred installation configuration.

Parent topic: Adaptive Server Upgrades