Complete the replication system configuration.
-
If the Database Information window indicates that there are incomplete
tasks on the Add Database to Replication System window, select each one
and complete the required information.
When all tasks are “Complete,” press Ctrl+A. A message is displayed
asking you if you want to execute the configuration.
-
Enter “y” to continue with the configuration.
Messages appear on the window as the configuration progresses; these
messages require no action.
Do not interrupt the configuration. Most configurations require several
minutes (sometimes longer) to complete.
When the configuration is complete, rs_init displays “Configuration
completed successfully.”
-
Click OK to return to the Configure Replication System window.
Note: To add other databases to the replication system, go to “Adding a
database to the replication system” section, and repeat the procedure
for each database.
-
Press Ctrl+X to navigate through the screens and exit the program. rs_init
displays the path to the log file for the session before you return to the
command prompt.
You can find out more about the progress of the installation by looking at the
current rs_init log file. rs_init log files are stored in the init/logs subdirectory of
the $SYBASE_REP directory.