Setting up and configuring non-ASE support

Set up and configure non-ASE support in Replication Server following these steps:

1. Create a replicate database connection ­– use the using profile clause with the create connection command to create a connection to a non-ASE replicate database. See “create connection with using profile clause,” in Chapter 3, “Replication Server Commands” in the Replication Server Reference Manual.

2. Create replicate definitions – see “Creating replication definitions,” in Chapter 9, “Managing Replicated Tables” in the Replication Server Administration Guide Volume 1.

3. Mark tables for replication – see “Marking tables for replication,” in Chapter 9, “Managing Replicated Tables” in the Replication Server Administration Guide Volume 1.

4. Create subscriptions – see Chapter 11, “Managing Subscriptions” in the Replication Server Administration Guide Volume 1.

Once you complete all these steps, you can begin replicating transactions to a non-ASE replicate database.

See the Replication Server Heterogeneous Replication Guide for information specific to supported non-ASE databases.