When you access a Sybase Adaptive Server Enterprise database in PowerBuilder through Open Client, Sec_Channel_Bind is one of several parameters that support login authentication for network-based security services. (For other login authentication parameters, see the See Also section.)
Sec_Channel_Bind controls whether your connection’s security mechanism performs channel binding. When Sec_Channel_Bind is set to 1, both Sybase Open Client Client-Library (CT-Lib) and the server provide a network channel identifier to the security mechanism before connecting. The channel identifier contains the network addresses of the client and server.
When Sec_Channel_Bind is set to 0 (the default), no channel binding is performed.
You must specify a value for Sec_Channel_Bind before connecting to the database.
Using third-party security mechanisms
For information about the third-party security
mechanisms and operating system platforms that Sybase has tested
with Open Client security services, see the Open Client documentation.
ASE, SYC Sybase Adaptive Server Enterprise
Sec_Channel_Bind=value
Sec_Channel_Bind=0
Not supported with CyberSafe Kerberos Sec_Channel_Bind is not supported if your security mechanism is CyberSafe Kerberos.
Set Release parameter For this parameter to take effect, you must also set the Release parameter to 11or higher to specify that your application should use the appropriate version of Sybase Open Client Client-Library (CT-Lib) behavior. See the description of the Release parameter for more information.
Requirements for use To use Sec_Channel_Bind or any other parameter supporting Open Client, you must meet certain requirements for using security services in your PowerBuilder application. For details, see “Requirements for using Open Client security services” in Connecting to Your Database.
Corresponding CT-Lib connection property Specifying a value for Sec_Channel_Bind sets the corresponding Sybase CT-Lib connection property named CS_SEC_CHANBIND.
To specify that your connection's security mechanism performs channel binding:
Database profile Select the Enable Channel Binding check box on the Security page in the Database Profile Setup dialog box.
Application Type the following in code:
SQLCA.DBParm="Sec_Channel_Bind=1"
