Loss Detection After Setting Log Recovery

While you are applying the temporary recovery database to the primary database, Replication Server may detect SQM loss between a primary database and the Replication Server that manages that primary database.

If all data is available, no intervention is necessary and the replication system can return to normal operations. The Replication Server logs a message such as:

No Loss Detected for DS1.PDB from DS1.PDB

If there were not enough messages, Replication Server logs a loss detection message similar such as:

Loss Detected for DS1.PDB from DS1.PDB

You must decide whether to ignore the losses by executing the ignore loss command, or repeat the recovery procedure from the beginning. To ignore the loss, enter the following command at the primary Replication Server:

ignore loss for DS1.PDB from DS1.PDB

If you received loss detection messages, you failed to reload the database to a state old enough to retrieve all of the messages. You must correctly determine which dumps to load.