Replication Server Executable Program

Use repserver or repsrvr.exe at the operating system prompt to run the Replication Server program.

For example, to run repserver, log in to the operating system as the “sybase” user, and execute repserver using the following syntax:

repserver [-C config_file] [-i id_server] [-S rs_name]
	[-I interfaces_file] [-E errorlog_file] [-M] [-v]
	[-K keytab_file]

See Replication Server Reference Manual > Executable Programs for complete information about each of the parameters of the repserver command.

The rs_init program creates the run file “RUN_name,” where name is the name of the Replication Server. The run file specifies the repserver command with parameters set for the installed Replication Server. Normally, you start Replication Server by executing the run file.

The Replication Server executable program is located in the bin subdirectory, and the Replication Server run file is in the install subdirectory of the Sybase release directory. Refer to the Replication Server installation and configuration guides for your platform for more information.