To perform the procedures in this section, open the interfaces session window using the instructions in “Open an editing session”.
After performing each procedure in this section, you
must click on Close Session to apply your edits to the interfaces
file. Clicking this button also closes the interfaces session window.
Click on Add new server entry.
Specify the name and network addresses for a new server entry.
Viewing or modifying a server entry
Click on Modify server entry.
Modify the attributes as desired.
Copying a server entry to another interfaces file
Use one of the following methods to select the entries to copy:
To copy a single entry, click it once.
To copy a range of consecutive entries, click the first entry in the range, press and hold down Shift, and click the last entry in the range. You can also select “backwards” by clicking the last entry, holding down Shift, and clicking the first entry.
To select multiple, nonconsecutive entries, press and hold down the Ctrl key while you click each entry.
Click Copy server entry.
Select the Sybase interfaces file from the list.
Edit the displayed file name.
Click OK.
