With large schemas, the default cache settings may be too small and the IQ 15.0 server could exhaust dynamic memory. To increase the 15.0 server's cache memory, use the -c server switch. Use the -new_startline to pass this switch to the 15.0 server.
A diagnostic example would include the following switches:
-ca 1 -c 1000m -o /iq15outputdir/iq15console.out
The value shown for -c is arbitrary.
You should set switches appropriately for your system. The value
for -c is in bytes. To specify megabytes, use
the m suffix, as shown.
The switches in the example perform as follows:
ca 1 – Enables dynamic catalog cache sizing. This will also cause memory cache statistics to be logged to the console.
c 1000m – Sets initial catalog cache at 1GB.
–-o /outputdir/iq15console.out Specifies the log file for console output.
Now you can load -o /outputdir/iq15console.out into your editor and examine the log entries. You can watch how the catalog store adjusts the cache and determine if the settings of 1000m and 2000m are appropriate.
