Copy your license to the license directory, and start the license server from a console or command line.
Prerequisites
If you installed your license server on Windows 7, you must use the Run as Administrator command to start and stop the license server.
Task
From a console or command line, copy the license file you
generated to the %SYBASE%\SYSAM-2_0\licenses
directory on the network license server.
Change to
%SYBASE%\SYSAM-2_0\bin,
then refresh or restart the license server:
Option
Description
sysam start
Start the license server.
Perform this step if the license server is not running. After
you perform this step, repeat step 2 to verify that the server is
running.
sysam reread
Make the license server read the new license file.
Perform this step if the license server is already started.
To verify that
the license server is running, enter sysam status.
Note: The SySAM License Server Installer installs both IPv4-only and IPv4/IPv6
dual-stack license server binaries during
installation and configures use of IPv4-only
binaries.
Use
the sysam configure[IPv6 | IPv4] to configure
the appropriate version of the license server. For example, sysam
configure IPv6 will configure use of the IPv4/IPv6 dual
stack binaries. For more information, see SySAM Users
Guide.