Ensure that the host on which you are upgrading
Sybase Unwired Platform 2.2 to SAP Mobile Platform 2.3
is ready for you to begin the upgrade.
In the Windows Services control panel, check
the startup type of all services with names that start with "Sybase." If any of
these services are set to Manual, change the setting to
Automatic.
Prevent backups from interfering.
You can either exclude the existing Unwired Platform installation
directory from backups or temporarily disable then.
Prevent virus scans from interfering.
You can either exclude the existing Unwired Platform installation
directory from virus scans or temporarily disable them.
Prevent system upgrades from interfering.
You can either exclude the existing Unwired Platform installation
directory from system upgrades or temporarily disable them.
To accommodate SAP Mobile Platform internal communications, you may need to
reconfigure intrusion detection/prevention systems (either hardware- or
software-based).
See Intrusion Detection and Protection
Requirements in Landscape Design and
Integration.
Verify that you have Administrator privileges on the upgrade
target host.
Shut
down all Sybase and SAP software, Sybase and SAP processes, and associated third-party processes
running on the installation target host.
Use the Services panel from Windows Control Panel to verify
that services are stopped. The Sybase Unwired Platform services are: “Sybase
Control Center” and all services with names that begin with “Sybase
Unwired…”
If User Access Control (UAC)
is present in the version of Windows where you are installing, disable it.
Restart the system for this change to take effect.
For Windows 8 installations, verify that the
Microsoft .NET Framework 3.5 has been enabled before starting the upgrade. If
not enabled, you must manually enable the .NET Framework 3.5 from the Windows
Features control panel applet before upgrading the
SAP Mobile Platform Runtime.