Configuring Connection Properties for Relay Server Components

In most highly available deployments, you configure both Relay Server and RSOE to use HTTP when connecting to Unwired Server on the corporate LAN. In more specialized, less available deployments (for example, where BES is inside the corporate LAN and is configured to connect directly to Unwired Server without any load-balancing by Relay Server), use HTTPS.

1. Configuring Relay Server Connection Properties
   Configure the connection type used by Relay Server to connect to the Unwired Server.
2. Configuring Outbound Enabler Connection Properties
   Outbound Enabler establishes two connections. You can configure connections from the Outbound Enabler to Relay Server to use either HTTP or HTTPS. However, connections from the Outbound Enabler to Unwired Server can only use HTTP, so this connection does not require configuration.