Unwired Platform Port Accommodation

Infrastructure provisioning must accommodate all ports required by Unwired Platform server components.

To accommodate Unwired Platform ports, you may need to:

Configure Unwired Platform servers to change port number assignments.

Note: You cannot change assignments of Unwired Platform reserved ports.
- You can change default port assignments when you install Unwired Platform server components. After installation, you can change port assignments using the Sybase Control Center (SCC) console.
- To change the port assigned to an SCC service, you must edit the XML configuration file for that service.
Note: If there is a conflict for port 2480 or 2481, Unwired Server will not start. In that event, you will not be able to use the SCC console to change those Unwired Server ports. To correct the problem, you must temporarily stop the service that uses the conflicting port, then start Unwired Server so you can change the port assignment from the SCC console.
Reserve ephemeral ports on Unwired Platform hosts, to prevent another process from using them.

Note: Even if the installer does not detect a conflict at install time, the Windows operating system may use additional ports in the 1024-65535 range at a later time. In that event, you may encounter intermittent problems starting Unwired Platform services.

Refer to Microsoft operating system documentation to learn how to reserve ephemeral ports.