Server Node ID |
the string that identifies the Unwired Server in the cluster. This
property is case-sensitive, and
must
match the value in the Relay Server configuration.
|
Unwired Server Port |
the port on which Outbound Enabler manages requests. |
Farm Type |
the type of request managed by the
Relay Server: Replication, Messaging or Webservice protocol. When configuring
Relay
Server
Outbound
Enabler
properties for a
scale-out
node, you can
select
only
the Webservice farm type.
|
Unwired Server Farm |
the string that identifies the Unwired
Server cluster, for which the Relay Server manages requests. This property is
case-sensitive, and it must match the value in the Relay Server
configuration. |
Relay Server Host |
for Relay Server farms that use a load balancer, the host name or IP
address of the load balancer. Otherwise, the host name or IP address
of
a single Relay Server. |
Status |
current state of the Outbound Enabler process: stopped, running, or error. |
Status Description |
additional details on the state of the
Outbound Enabler. If you receive one of these messages,
follow the documented recommendation: - Unknown error state – Check the log for additional
details.
- Failed to connect Unwired
Server, retrying... – Check the Unwired Server port
managed by the Outbound Enabler.
- Unauthorized. – Check the security token of
Outbound Enabler.
- Unrecognized farm or server node
ID. – The string that identifies the
Unwired Server cluster or server node in the
Outbound Enabler configuration does not match the
Relay Server configuration.
- Please check the relay server
host and port or Failed to create I/O stream to
the relay server – If you use HTTPS port, check to
see if the certificate file is valid.
- Relay server service
unavailable. – Check if the Relay Server is
properly configured, or if any internal errors are
logged.
- Relay server not found. – Either the Relay Server is not
yet deployed, or the URL suffix is wrong.
- Bad request. – Check the syntax of the URL
suffix.
- Error writing HTTP headers – Check if the trusted certificate
is valid, and verify the URL suffix syntax.
Something may be misformatted.
Note:
Sometimes when the Status column shows "Running" the
Status Description shows:
Relay Server outbound enabler is running. Please check the log file to confirm the status.
In these cases, the console may detect that an RSOE is
running, even though the RSOE is actually in an error
state. - The RSOE log level is set too high (4 or 5).
Sybase Control Center cannot detect the status
from scanning the RSOE log.
- The RSOE enters an unrecognized error condition.
For example, when RSOE connects to Relay Server
through an Internet proxy server, if the proxy
server shuts down, the RSOE is effectively in an
error state. The RSOE may continue to retry the
connection indefinitely, and produce no log
message recognized as an error.
|
Certificate File |
the certificate file uploaded to the Unwired Server certificate store. |
Log File |
the name and
location of the Outbound Enabler log file. The syntax of this filename is <nodeName>.RSOE<n>.log. <n> is the primary key of the Outbound
Enabler database record in the cluster database used by Unwired Platform. |