Starting and Stopping Sybase Control Center in Unwired Platform

Sybase Unified Agent is used to start and stop Sybase Control Center.

There are two ways to start and stop the Sybase Control Center in an Unwired Platform environment.

By default, SybaseControlCenterX.X is installed to run as a Windows service, and is set by the installer to start automatically.
You can also use a command-line script as required.

Start or stop from the Windows Control Panel; change automatic start and restart:
1. Open the Windows Control Panel.
2. Select Administrative Tools > Services.
3. Locate SybaseControlCenterX.X. If the service is running, the status column displays “Started.”
4. To start or stop the service, right-click the service and choose Start or Stop.
5. Double-click the service.
6. To set the service to automatically start when the system starts, change the Startup type to Automatic.
7. To restart the service in case of failover, choose the Recovery tab and change the First, Second, and Subsequent failures to Restart Service.
  Click Apply to save the modifications before closing the dialog.
Manually starting Sybase Control Center by command-line script:
1. Enter the start command:
```
<UnwiredPlatform_InstallDir>\SCC-X_X\bin\scc.bat
```
Manually stopping Sybase Control Center by command-line script:
1. Enter the stop command:
```
<UnwiredPlatform_InstallDir>\SCC-X_X\bin\scc.bat -stop
```
  Note: You can use scc.bat -stop only to stop an SCC that was manually started with "scc.bat"; it cannot stop the SCC windows service.