Updating Server Connection Properties

Configure the production version of server connection properties. Typically, the endpoint and role mapping a developer would use are not the same for a production system. Administrators must reset these properties accordingly.

This step allows you to change connection profiles used for development (design time) to an appropriate server-side connection. For example, your development environment might permit access to certain systems that the Unwired Server prohibits.

Note: If the connection properties of an MBO or operation use credentials that have been customized manually by a developer, the back-end data sources connection properties of these MBOs and operations cannot be updated by an administrator when using the Deploy Wizard.

Instead, the adminstrator can update these properties after the MBO or operation is deployed to an Unwired Server. When the server connection is created on Unwired Server, the administrator can then change connection properties in Sybase Control Center by clicking on the Connections node in the left navigation pane.

Review the connection properties.
Depending on how the properties are configured, choose an appropriate option:
- If the properties are configured by the developer as a set of connection properties, you can edit properties as needed. To edit a property, click a field in the Value column and change the value as required.
- If the properties are configured as an endpoint, choose the connection pool you want Unwired Server to use. You cannot alter any of these properties.
If you want the changes to apply to operations only, click the corresponding check box at the bottom of the table.
Click Next.

The connection properties are updated. The changes you make are displayed in the Summary page in the Endpoint Updates section.