Verifying the Cluster Configuration

Verify that the cluster configuration is running and that you can connect to it.

  1. If sybcluster is not running, start it. Enter: 
    sybcluster -U uafadmin -P -C cluster_name -F "node_name[:port_num]
    [,node_name[:port_num]]..."
    This statement identifies the default cluster and the Unified Agents on each node in the cluster. If you do not enter this information on the sybcluster command line, you can enter it in the following step. See the Clusters Users Guide for more information.
  2. Connect to the cluster. Enter: 
    connect
  3. Start the cluster. Enter: 
    start cluster
  4. Verify that the cluster is running. Enter: 
    show cluster status
  5. Verify the cluster configuration. Enter: 
    show cluster config
Parent topic: Creating a Cluster Using sybcluster