Troubleshooting Common Installation Problems

Identify the cause of installation problems and apply the recommended solutions.

ProblemResolution
Cannot use X-Windows.
If the setup and configuration utilities do not show correctly, you may need to adjust the resolution on your monitor.
To change to a smaller font size, issue the following UNIX commands:
% cd $SYBASE/ASE-15_0
% chmod +w xappdefaults
% cd xappdefaults
% chmod +w *
% foreach i(*) 
? cat $i | sed -e "s/140/100/g" | sed -e "s/^#D/D/g" | sed -e "s/^#S/S/g" > p
? mv p $i
? end
%
The installation utilities will now use approximately 25 percent less window space.
Cannot eject the CD or DVD from the drive.
If you cannot eject the CD from the drive, check:
  • To see whether the disk drive path is the current directory (pwd) in a UNIX terminal window. If it is, change (cd) to another directory.
  • For sybhelp processes. If these processes exist, kill them using the UNIX kill command.
DISPLAY environment variable not set correctly.
The resolution to the DISPLAY variable problem should instruct you to open Exceed (under Hummingbird Connectivity) and set DISPLAY equal to hostname:b, where b is the number in the parentheses following Exceed in the Exceed window.
Client not authorized to connect to server.
This error message means the remote machine does not have permission to display the user interface on the local machine where you start working:
Xlib: connection to "host_name" refused by server
Xlib: Client is not authorized to connect to Server
xhost: unable to open display "host_name"
To correct the problem:
  1. Enter the following command at the UNIX prompt of your local machine, where remote_machine is the machine on which you are running the installer:
    xhost +remote_machine
  2. Restart the installer.
Address already in use.
Enter a different port number on the srvbuild window. The command netstat -a produces a list of port numbers in use.
Adaptive Server fails to start.
The shared memory of the operating system may not be set high enough. Adjust the shared memory value. Restart the installation or upgrade process.
The installer fails to start.

Restart the installer in debug mode. Set the environment variable LAX_DEBUG to true before running the installer.

Cannot start XP Server.
You may receive the following message from XP Server when it is invoked by xp_cmdshell or some other extended stored procedure:
Msg 11018, Level 16, State 1:
Procedure "xp_cmdshell", Line 2:
XP Server must be up for ESP to execute.
(return status = -6)

Verify that there is an XP Server entry in the Adaptive Server sysservers table. If you created XP Server in a different srvbuild session than Adaptive Server and you did not specify a related Adaptive Server, srvbuild cannot update the sysservers table. Verify that the XP server exists in the interfaces file or LDAP server.

Use sp_addserver to add an entry to the sysservers table.

Troubleshooting resource file installations.
If you encounter problems during the build, configuration, or upgrade process while using the srvbuild[res], sqlloc[res], or sqlupgrade[res], it may be that these utilities did not allow enough time for Adaptive Server to shut down properly. Set the SYBSHUTWAIT environment variable to force the utilities to wait for Adaptive Server to shut down. For example, this command forces the utility to wait for two minutes before proceeding with the next task:
% setenv SYBSHUTWAIT 120
Parent topic: Troubleshoot the Server