Display RTL Information

You can display information on configuration parameter properties and table references.

Display Configuration Parameter Properties

Use admin config to view information about database-level and table-level configuration parameters as shown in the examples.

Database-level:
- To display all database-level configuration parameters for the connection to the iqdb database of the IQSRVR data server (IQSRVR.iqdb), enter:
```
admin config, “connection”, IQSRVR, iqdb
```
- To verify that dsi_compile_enable is on for the connection to IQSRVR.iqdb, enter:
```
admin config, “connection”, IQSRVR, iqdb,dsi_compile_enable
```
- To display all the database-level configuration parameters that have "enable" as part of the name, such as dsi_compile_enable, enter:
```
admin config, “connection”, IQSRVR, iqdb,"enable"
```
  Note: You must enclose "enable" in quotes because it is a reserved word in Replication Server. See "Reserved words," in Chapter 2, "Topics" in the Replication Server Reference Manual for the list of reserved words.
Table-level:
- To display all configuration parameters after using dsi_command_convert to set d2none on the tb1 table in the iqdb database of the IQSRVR data server, enter:
```
admin config, “table”, IQSRVR, iqdb
```

See “admin config,” in Chapter 3, “Replication Server Commands” in the Replication Server Reference Manual for syntax, parameters, and more examples.

Display Table References

Use the rs_helprep stored procedure which you can execute on the Replication Server System Database (RSSD) to view information about table references and RTL information.

To display information about the authors_repdef replication definition created using create replication definition, enter:
```
rs_helprep authors_repdef
```

See "rs_helprep," in Chapter 6, " RSSD Stored Procedures" in the Replication Server Reference Manual for syntax, parameters, and more examples.