Messages on this page are sorted by Sybase error code. Locate the appropriate code for a full description of the message.
Error 1013061 | "Missing row delimiter detected during a row delimited insert. %1" |
---|---|
Constant | EMSG_SQL_MISSINGROWTERMINATOR |
SAP Sybase Error Number | 20631 |
SQL State | QCA61 |
SQL Code | -1013061L |
ODBC 2 State | ERROR |
ODBC 3 State | ERROR |
Severity Code | |
Parameter 1 | location of the exception |
Probable Cause | The input data is missing a row delimiter. |
Error 1013062 | "Expected '%2' delimited column type on input, but encountered a row delimiter instead. Probable cause is a mismatch between the specified column delimiter and the column delimiter used in the input file. %1" |
---|---|
Constant | EMSG_SQL_EXPECTEDFIELDTYPENOTSEEN |
SAP Sybase Error Number | 20632 |
SQL State | QCA62 |
SQL Code | -1013062L |
ODBC 2 State | ERROR |
ODBC 3 State | ERROR |
Severity Code | |
Parameter 1 | location of the exception |
Parameter 2 | expected datatype of column |
Probable Cause | A row delimiter, rather than a column, was encountered during a LOAD. Probable cause is a mismatch between the specified column delimiter and the column delimiter used in the input file. |
Error 1013063 | "Expected raw-data column type '%2' on input, but no input data exists. %1" |
---|---|
Constant | EMSG_SQL_EXPECTEDRAWFIELDTYPENOTSEEN |
SAP Sybase Error Number | 20633 |
SQL State | QCA63 |
SQL Code | -1013063L |
ODBC 2 State | ERROR |
ODBC 3 State | ERROR |
Severity Code | |
Parameter 1 | location of the exception |
Parameter 2 | column datatype |
Probable Cause | No data was found during a scan of an input file during insert. |
Error 1013064 | "Row delimiter not seen during scan of input file. At least one of the input rows is missing a terminator. %1" |
---|---|
Constant | EMSG_SQL_ROWTERMINATORNOTSEEN |
SAP Sybase Error Number | 20634 |
SQL State | QCA64 |
SQL Code | -1013064L |
ODBC 2 State | ERROR |
ODBC 3 State | ERROR |
Severity Code | |
Parameter 1 | location of the exception |
Probable Cause | A row delimiter has been omitted from an input file. |
Error 1013065 | "Row delimiter '%2' and column delimiter '%3' cannot be substrings of each other. %1" |
---|---|
Constant | EMSG_SQL_CANTBESUBSTRING |
SAP Sybase Error Number | 20635 |
SQL State | QCA65 |
SQL Code | -1013065L |
ODBC 2 State | ERROR |
ODBC 3 State | ERROR |
Severity Code | |
Parameter 1 | location of the exception |
Parameter 2 | the row delimiter |
Parameter 3 | the column delimiter |
Probable Cause | Row and column delimiters cannot be substrings of each other. |
Error 1013066 | "The %2 load option can be specified only once. %1" |
---|---|
Constant | EMSG_SQL_MULTIPLE_LOAD_OPTION |
SAP Sybase Error Number | 20636 |
SQL State | QCA66 |
SQL Code | -1013066L |
ODBC 2 State | ERROR |
ODBC 3 State | ERROR |
Severity Code | |
Parameter 1 | location of the exception |
Parameter 2 | name of the load option |
Probable Cause | The named load option can be specified only once per LOAD statement. |
Error 1013067 | "Option CONVERSION ERROR must be OFF when IGNORE CONSTRAINT DATA VALUE or ALL is specified. %1" |
---|---|
Constant | EMSG_SQL_DATAVALUE_CVTERROR |
SAP Sybase Error Number | 20637 |
SQL State | QCA67 |
SQL Code | -1013067L |
ODBC 2 State | ERROR |
ODBC 3 State | ERROR |
Severity Code | |
Parameter 1 | location of the exception |
Probable Cause | When IGNORE CONSTRAINT DATA VALUE or ALL is given on a load statement, the database option CONVERSION ERROR must be off. |
Error 1013068 | "Constraint '%2' violated: Invalid value for column '%3' in table '%4'. %1" |
---|---|
Constant | EMSG_SQL_COLUMN_CHECK_CONSTRAINT_VIOLATED |
SAP Sybase Error Number | 20638 |
SQL State | QCA68 |
SQL Code | -1013068L |
ODBC 2 State | ERROR |
ODBC 3 State | ERROR |
Severity Code | |
Parameter 1 | location of the exception |
Parameter 2 | constraint name |
Parameter 3 | column name for which the violation occurred |
Parameter 4 | table name |
Probable Cause | The Data being inserted or updated is invalid due to a column check constraint violation. |
Error 1013070 | "Cannot specify check constraints off and ignore all, ignore check, log all or log check during load. %1" |
---|---|
Constant | EMSG_SQL_IQ_LOAD_CONFLICT |
SAP Sybase Error Number | 20640 |
SQL State | QCA70 |
SQL Code | -1013070L |
ODBC 2 State | ERROR |
ODBC 3 State | ERROR |
Severity Code | |
Parameter 1 | location of the exception |
Probable Cause | when check constraints off is specified during load ignore all, ignore check, log all, log check are not available. |
Error 1013071 | "Constraint '%2' violated: Invalid value in table '%3'. %1" |
---|---|
Constant | EMSG_SQL_TABLE_CHECK_CONSTRAINT_VIOLATED |
SAP Sybase Error Number | 20641 |
SQL State | QCA71 |
SQL Code | -1013071L |
ODBC 2 State | ERROR |
ODBC 3 State | ERROR |
Severity Code | |
Parameter 1 | location of the exception |
Parameter 2 | constraint name |
Parameter 3 | table name on which the table check violation occurred |
Probable Cause | The Data being inserted or updated is invalid due to a table check constraint violation. |
Error 1013077 | "ROW DELIMITED BY is valid only when all columns are delimited or ASCII fixed-width. %1" |
---|---|
Constant | EMSG_SQL_INVALIDUSEOFROWTERMINATOR |
SAP Sybase Error Number | 20647 |
SQL State | QCA77 |
SQL Code | -1013077L |
ODBC 2 State | ERROR |
ODBC 3 State | ERROR |
Severity Code | |
Parameter 1 | location of the exception |
Probable Cause | ROW DELIMITED BY is valid only when all columns are delimited or ASCII fixed-width. You cannot use a row delimiter with PREFIX or BINARY columns. |
Error 1013078 | "Insert Pass 1 CPU utilization" |
---|---|
Constant | EMSG_FFINSERT_1 |
SAP Sybase Error Number | 20648 |
SQL State | QCA78 |
SQL Code | -1013078L |
ODBC 2 State | ERROR |
ODBC 3 State | ERROR |
Severity Code | |
Probable Cause | This is displayed as part of an informational message during insert. |
Error 1013079 | "Insert Pass 1 user (%)" |
---|---|
Constant | EMSG_FFINSERT_1U |
SAP Sybase Error Number | 20649 |
SQL State | QCA79 |
SQL Code | -1013079L |
ODBC 2 State | ERROR |
ODBC 3 State | ERROR |
Severity Code | |
Probable Cause | This is displayed as part of an informational message during insert. |
Error 1013080 | "Insert Pass 1 system (%)" |
---|---|
Constant | EMSG_FFINSERT_1S |
SAP Sybase Error Number | 20650 |
SQL State | QCA80 |
SQL Code | -1013080L |
ODBC 2 State | ERROR |
ODBC 3 State | ERROR |
Severity Code | |
Probable Cause | This is displayed as part of an informational message during insert. |
Error 1013081 | "Insert Pass 2 CPU utilization" |
---|---|
Constant | EMSG_FFINSERT_2 |
SAP Sybase Error Number | 20651 |
SQL State | QCA81 |
SQL Code | -1013081L |
ODBC 2 State | ERROR |
ODBC 3 State | ERROR |
Severity Code | |
Probable Cause | This is displayed as part of an informational message during insert. |
Error 1013082 | "Insert Pass 2 user (%)" |
---|---|
Constant | EMSG_FFINSERT_2U |
SAP Sybase Error Number | 20652 |
SQL State | QCA82 |
SQL Code | -1013082L |
ODBC 2 State | ERROR |
ODBC 3 State | ERROR |
Severity Code | |
Probable Cause | This is displayed as part of an informational message during insert. |
Error 1013083 | "Insert Pass 2 system (%)" |
---|---|
Constant | EMSG_FFINSERT_2S |
SAP Sybase Error Number | 20653 |
SQL State | QCA83 |
SQL Code | -1013083L |
ODBC 2 State | ERROR |
ODBC 3 State | ERROR |
Severity Code | |
Probable Cause | This is displayed as part of an informational message during insert. |
Error 1013084 | "Insert Commit CPU utilization" |
---|---|
Constant | EMSG_FFINSERT_COMMIT |
SAP Sybase Error Number | 20654 |
SQL State | QCA84 |
SQL Code | -1013084L |
ODBC 2 State | ERROR |
ODBC 3 State | ERROR |
Severity Code | |
Probable Cause | This is displayed as part of an informational message during insert. |
Error 1013085 | "Insert Commit user (%)" |
---|---|
Constant | EMSG_FFINSERT_COMMITU |
SAP Sybase Error Number | 20655 |
SQL State | QCA85 |
SQL Code | -1013085L |
ODBC 2 State | ERROR |
ODBC 3 State | ERROR |
Severity Code | |
Probable Cause | This is displayed as part of an informational message during insert. |
Error 1013086 | "Insert Commit system (%)" |
---|---|
Constant | EMSG_FFINSERT_COMMITS |
SAP Sybase Error Number | 20656 |
SQL State | QCA86 |
SQL Code | -1013086L |
ODBC 2 State | ERROR |
ODBC 3 State | ERROR |
Severity Code | |
Probable Cause | This is displayed as part of an informational message during insert. |