UDP gateway properties allow you to change the behavior of an UDP gateway, such as the IP address and the port number. All UDP gateway properties are optional. For more information about setting these properties, see MobiLink server settings for server-initiated synchronization.
| Property | Value | Description |
|---|---|---|
| confirm_action | { yes | no } | Specifies whether confirmation is sent on delivery through this gateway. The default value is no. |
| confirm_delivery | { yes | no } | Specifies whether this gateway confirms delivery. The default value is yes. |
| confirm_timeout | number{ s | m | h } |
Specifies the amount of time to wait before confirmations timeout. The following is a list of acceptable time units:
The default value is 1m. Time units can be combined in the HHh MMm SSs format. If a time unit is not specified, time is measured in seconds. |
| description | description_text | Describes the gateway. |
| enable | { yes | no } | Specifies whether the UDP gateway should be used. |
| Listeners_are_900 | { yes | no } | Specifies whether all MobiLink Listeners are SQL Anywhere 9.0.0 clients. The default value is no. For SQL Anywhere 9.0.1 clients or later, leave this value at no. |
| Listener_port | port_number | Specifies the port that the remote devices uses to send UDP packets. The default value is 5001. |
| sender | IP_address_or_hostname | Used for multi-homed hosts only. Specifies the IP address or hostname of the sender. The default value is localhost. |
| sender_port | port_number | Specifies the port number used to send UDP packets. By default, a free port number is randomly assigned by the operating system. |
 |
Discuss this page in DocCommentXchange.
|
Copyright © 2012, iAnywhere Solutions, Inc. - SQL Anywhere 12.0.1 |