Recording Replication Extract installation panel
information:
Record the DB2 subsystem ID in section 4a, “DB2 subsystem ID (db2ssid),” on the Replication Agent Installation Worksheet.
If you are running DB2 in nondata-sharing mode, the DB2 subsystem ID should identify the subsystem ID of the member from which you are replicating transaction information.
If you are running DB2 in data-sharing mode, the DB2 subsystem ID should identify the name of the data-sharing group.
Record the log extract plan name in section 4b, “Log extract plan name,” on the Replication Agent Installation Worksheet. The default value is RAPLAN.
If you are upgrading from an earlier version of Replication Agent that you are installing on the same DB2 subsystem as an older version, select a different plan name to prevent overlaying the old plan.
If you change the name of the log extract plan, you
must also change the plan value for parameter LTMPlan in
the LTM configuration and the LTMBIND member
of the JCL library.
Obtain the DB2 SDSNEXIT library name from your systems programmer. Record this name in section 4c of the Replication Agent Installation Worksheet.
Obtain the DB2 SDSNLOAD library name from your systems programmer. Record this name in section 4d of the Replication Agent Installation Worksheet.
Record the version of DB2 UDB you are using with Replication Agent in section 4g of the Replication Agent Installation Worksheet.
